NO:411860,Fendi, Coral Printed Short-sleeved T-shirt Fabric Selection: It is made of high-stretched long-length cotton. The warp and weft density can reach 1,000 pieces/inch. The cloth surface is tight and flat, and the touch is smooth like silk. The high-density structure enhances the durability of the fabric, is not easy to pill and deform, and has good wrinkle resistance. Cotton fibers are naturally skin-friendly, breathable and hygroscopic, and are soft and non-irritating. Process 1 The coral flower pattern is presented on the fabric through glue printing, with uniform spatula pressure. The chest patch sheet is scratched by the printer for 30 times to ensure that the printing thickness presents a micro three-dimensional convex structure, and the glue is fully penetrated and covered. The back sheet printing is relatively thin after 7 scratches, but it does not hinder its beauty and firmness. Finally, after high-temperature curing, the pigment is firmly combined with the cotton fiber, and the ink-absorbing characteristics of the cotton fiber make the pattern not easily fall off due to friction. Process 2 The fabric is uniformly humidified by steam, squeezed with a heated roller and an elastic rubber blanket, forcing the fibers to retract, and finally cooled down through cold air to fix the form. After treatment, the shrinkage rate is controlled within 3. Sizes S-XL,,fendi,T-shirt,tees,t-shirt,alexander wang19860909Fendi,珊瑚花印花短袖T恤 面料选择 选用高支长绒棉编织而成 ,经纬密度可达1000根/英寸,布面紧密平整,触感光滑如丝绸,高密度结构增强了面料的耐用性,不易起球变形,且有良好的抗皱性.棉纤维具有天然的亲肤性,透气性和吸湿性并存,贴身柔软,无刺激. 工艺1 通过胶浆印花在面料上呈现珊瑚花图案,刮刀压力均匀,胸贴袋片经过印花师30次刮印确保印花厚度呈现微立体凸起结构,并使胶浆充分渗透并覆盖.后片印花经过7次刮印相对较薄,但同样不妨碍其美感和牢固度.最后通过高温固化后,颜料与棉纤维结合牢固,棉纤维的吸墨渗透特性使图案不易因摩擦导致脱落. 工艺2 面料经蒸汽均匀加湿,用加热后的辊筒与弹性橡胶毯挤压,迫使纤维回缩,最后通过冷风降温固定形态.经过处理之后将缩水率控制在3以内. 尺码S-XL,,fendi,T-shirt,tees,t-shirt,alexander wang,Men's clothing